POOSHESH STEELPERGAS
فا

ENAW-AlMgSi

Wrought Aluminum Alloys

OverviewChemical CompositionMechanical PropertiesPhysical PropertiesOther Properties

Property Overview

Density2.7g/cm³
Elastic ModulusUnknown
Tensile Strength120MPa
Yield Strength60MPa
Brinell Hardness35HB
Maximum Service TemperatureUnknown
Weight Calculator

Chemical Composition

Mechanical

A - Min. elongation Lo = 50mm (%) (T4)
14
A - Min. elongation Lo = 50mm (%) (T5)
6
A - Min. elongation Lo = 50mm (%) (T6)
6
A - Min. elongation at fracture (%) (T4)
16
A - Min. elongation at fracture (%) (T5)
8
A - Min. elongation at fracture (%) (T6)
8
R p0.2 0.2% proof strength (MPa) (T4)
60
R p0.2 0.2% proof strength (MPa) (T5)
100-120
R p0.2 0.2% proof strength (MPa) (T6)
140-150
Rm - Tensile strength (MPa) (T4)
120
Rm - Tensile strength (MPa) (T5)
140-160
Rm - Tensile strength (MPa) (T6)
170-190

Hardness

Brinell hardness (HBW): (O)
35
Brinell hardness (HBW): (T4)
50
Brinell hardness (HBW): (T5)
60
Brinell hardness (HBW): (T6)
70
Registered Designations & Aliases
ENAW-6060ENAW-AlMgSi
Standards

EN 12392 EN 12392: 2000 Aluminium and aluminium alloys. Wrought products. Special requirements for products intended for the production of pressure equipment

EN 1301-2 EN 1301-2: 1997 Aluminium and aluminium alloys. Drawn wire. Mechanical properties

EN 1715-3 EN 1715-3: 2008 Aluminium and aluminium alloys. Drawing stock. Specific requirements for mechanical uses (excluding welding)

EN 570 EN 570: 2007 Aluminium and aluminium alloys. Impact extrusion slugs obtained from wrought products. Specification

EN 573-3 EN 573-3: 2009 Aluminium and aluminium alloys. Chemical composition and form of wrought products. Chemical composition and form of products

EN 754-2 EN 754-2: 2008 Aluminium and aluminium alloys. Cold drawn rod/bar and tube. Mechanical properties

EN 755-2 EN 755-2: 2008 Aluminium and aluminium alloys. Extruded rod/bar, tube and profiles. Mechanical properties