5026 (AlMg4.5MnSiFe, A95026) Aluminum
Wrought Aluminum Alloys
annealed
Property Overview
Density2.8g/cm³
Elastic Modulus70GPa
Tensile Strength260MPa
Yield Strength120MPa
Brinell HardnessUnknown
Maximum Service Temperature210°C
Chemical Composition
CR
0 to 0.3%
MN
0.6 to 1.8%
SI
0.55 to 1.4%
CU
0.1 to 0.8%
TI
0 to 0.2%
AL
88.2 to 94.7%
MG
3.9 to 4.9%
RES.
Residuals res. | | 0 to 0.15%
RESIDUALS RES.
0 to 0.15%
ZN
0 to 1.0%
ZR
0 to 0.3%
FE
0.2 to 1.0%
Mechanical
Elastic (Young's, Tensile) Modulus
70 GPa
Elongation at Break
10 %
Fatigue Strength
120 MPa
Poisson's Ratio
0.33
Shear Modulus
26 GPa
Shear Strength
150 MPa
Tensile Strength: Ultimate (UTS)
260 MPa
Tensile Strength: Yield (Proof)
120 MPa
Physical
Density
2.8 g/cm 3
Thermal
Latent Heat of Fusion
400 J/g
Maximum Temperature: Mechanical
210 °C
Melting Completion (Liquidus)
650 °C
Melting Onset (Solidus)
510 °C
Specific Heat Capacity
890 J/kg-K
Thermal Conductivity
130 W/m-K
Thermal Diffusivity
52 mm 2 /s
Thermal Expansion
23 µm/m-K
Thermal Shock Resistance
11 points
Electrical
Electrical Conductivity: Equal Volume
31 % IACS
Electrical Conductivity: Equal Weight (Specific)
99 % IACS
Calculated
Resilience: Ultimate (Unit Rupture Work)
22 MJ/m 3
Resilience: Unit (Modulus of Resilience)
100 kJ/m 3
Stiffness to Weight: Axial
14 points
Stiffness to Weight: Bending
49 points
Strength to Weight: Axial
26 points
Strength to Weight: Bending
33 points
Environmental
Base Metal Price
9.5 % relative
Embodied Carbon
8.9 kg CO 2 /kg material
Embodied Energy
150 MJ/kg
Embodied Energy
150 MJ/kg 66 x 10 3 BTU/lb
Embodied Water
1150 L/kg
Embodied Water
1150 L/kg 140 gal/lb
Registered Designations & Aliases
5026 (AlMg4.5MnSiFe, A95026) AluminumA95026AlMg4.5MnSiFeEN AW-5026
Standards
EN 485-2 EN 485-2: Aluminium and aluminium alloys. Sheet, strip and plate. Mechanical properties
EN 573-3 EN 573-3: Aluminium and aluminium alloys. Chemical composition and form of wrought products. Chemical composition and form of products
ISO 6361-2 ISO 6361-2: Wrought aluminium and aluminium alloys - Sheets, strips and plates - Part 2: Mechanical properties